Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
2-62 Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide
Hardware Overview Introduction
Tx
This LED shows transmit activity from the line card. Any packet
(except Usage and IPS packets) transmitted by the MAC will
cause the LED to blink. Transit traffic will not cause the LED to
flash.
Wrap Off – No wrap anywhere in ring, or not part of ring.
Green, solid – Not wrapped, but a wrap exists elsewhere in the ring;
overall performance is degraded.
Green, blinking – Wrapped, no fault on this side – transmit/receive OK.
Amber solid – Wrapped, no fault on this node, but fault detected at
other end of fiber link.
Amber, blinking – Wrapped, fault on this side of the SRP node.
Table 2-60 LED description for SRP line card (Continued)
LED Description