Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide 2-59
Introduction Hardware Overview
Figure 2-44 SRP bridge module
Figure 2-45 SRP line card pair shown in an RS 8000 chassis
G8M-SRP-MATE
This module
must be
removed prior
to removing
line-cards.
Side B
Caution
Side A
21 21
87654321
87654321
87
6
5
4
3
21
G8M-CM CONTROL MODULE
10/100BASE-TXG8M-HTXA2-08
10/100BASE-TXG8M-HTXA2-08
1000BASE-LXG8M-GLXA9-02 1000BASE-SXG8M-GSXA1-02
100BASE-FXG8M-HFXA1-08
G80-PAC
100-125~5A
200-240~3A
50-60 Hz
PWR
G80-PAC
100-125~5A
200-240~3A
50-60 Hz
PWR
6
4
2
7
5
3
CM/1
PS2PS1
CM
G80-CHS
RS-8000
G8M-S48DM-01
SRP
Single-Side
Hot
Swap
SFP
Sync
Pass
Wrap
Rx
State/Alarm
Offline
Online
Link
Side A
G8M-S48DM-01
SRP
Single-Side
Hot
Swap
SFP
Sync
Pass
Wrap
Rx
State/Alarm
Offline
Online
Link
Side A
G8M-SRP-MATE
This module
must be
removed prior
to removing
line-cards.
Side B
Caution
Side A
Board B
Board A
Bridge
Board
SRP Boards Must
Be In Vertically
Adjacent Slots
(Base Slot)
Tx
Tx