Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
2-54 Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide
Hardware Overview Introduction
Figure 2-41 Clear channel T3 and E3 WICs
Table 2-51 through Table 2-54 list the specifications for the various WICs supported by the Multi-rate WAN line card.
Table 2-51 Specifications for T1 WIC card
Port type Specification
Channelized T1
•
Two RJ-48c connectors
•
ANSI T1.102, T1.107, T1.403 compliant
•
Supports SF/ESF
•
Supports AMI/B8ZS
Table 2-52 Specifications for E1 WIC card
Port type Specification
Channelized E1
•
Two RJ-45 connectors
•
G.703, G.704, and 732 compliant
•
G.704 framing
•
HDB3, AMI
Table 2-53 Specifications for Clear Channel T3 WIC card
Port-type Specification
Clear Channel T3
•
75-ohm coaxial BNC connectors
•
ANSI T1.102, T1.107, and T1.404a compliant
•
Supports M23 and C-bit framing
•
B8ZS
TX
RX
WIC T3-1B
Loop
Link
Tx
Rx
TX
RX
WIC E3-1B
Loop
Link
Tx
Rx