Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide 2-51
Introduction Hardware Overview
Figure 2-36 50-pin HSSI connector
The Dual HSSI line card uses the following LEDs.
CMTS Line Card
The CMTS 4x1 line card shown in Figure 2-37 and the CMTS 6X1 shown in Figure 2-38 support one transmit
(downstream) and four or six receive (upstream) ports. The RS 8000/8600 chassis with the CMTS line card provides
wire-speed Cable Modem Termination Service (DOCSIS 1.1, DOCSIS 1.0, and EuroDOCSIS 1.0) integration.
Figure 2-37 Cable Modem Termination Service (CMTS) 4-port line card
Table 2-48 LED description for Dual HSSI line card
LED Description
Offline When lit, this amber LED on the left side of the line card indicates that the line
card is offline (powered off) but is ready for hot swap.
The Offline LED also is lit briefly during a reboot or reset of the RS but goes
out as soon as the Control Module discovers the line card.
Online When lit, this green LED indicates that the line card is online and is ready to
receive, process, and send packets if configured to do so.
Link Indicates that the line card detects a cable plugged into the port and a good
link is established.
Rx Indicates when the port’s transceiver receives data.
Tx Indicates when the port’s transceiver transmits data.
DOCSIS CMTSG8M-CMTSNA-4X1
US 1 US 2 US 3 US 4 IF DS
Hot
Swap
Offline
Online
Link Rx Link Link LinkRx Rx Rx Tx