Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
2-46 Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide
Hardware Overview Introduction
Figure 2-32 Front panel of the MPLS POS-OC12c line card
Table 2-40 lists the media specifications for the MPLS POS OC-3c and MPLS POS OC-12c line cards.
Table 2-41 lists the LEDs used by the MPLS POS line cards.
Table 2-40 Cabling and connectors for MPLS POS OC-3c/OC-12c
line cards
Port type Specification
POS OC-3c and OC-12c
•
Bellcore GR253, ITU -T G.957,
ITU-T G.958
•
PPP over SONET/SDH (RFC 1619),
PPP in HDLC framing (RFC 1662)
•
Supports standard SFP pluggable
optics (Small Form-factor Pluggable
Transceiver Multi Source
Agreement)
Table 2-41 LED description for MPLS POS OC-3c/OC-12c line card
LED Description
Offline When lit, this amber LED on the left side of the line card indicates that
the line card is offline (powered off) but is ready for hot swap
The Offline LED also is lit briefly during a reboot or reset of the RS
but goes out as soon as the Control Module discovers the line card
Online When lit, this green LED indicates that the line card is online and is
ready to receive, process, and send packets if configured to do so
Per-port Link Solid Green – when PPP has negotiated any NCP protocol
(BNCP/IPCP/MPLSCP/IPXCP/OSICP)
Off – indicates that PPP has NOT negotiated any NCP protocol
G8M-P12MM-02
Hot
Swap
Offline
Online
18-695-01
POS MPLS OC-12c/STM-4
1
Link
Alm
Tx
Rx
2
Link
Alm
Tx
Rx