Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide 2-41
Introduction Hardware Overview
Figure 2-26 shows the front panel of the ATM OC-12c SMF line card.
Figure 2-26 Front panel of ATM OC-12c SMF line card
The following table lists the media specifications for the ATM OC-12c MMF and ATM OC-12c SMF line card.
The ATM OC-12c SMF and ATM OC-12c MMF line cards use the following LEDs.
Table 2-34 Cabling and connectors for ATM OC-12c line card
Port type Specification
ATM O C- 1 2c
•
SC-style Media Interface Connector (MIC); either
connection pin in the MIC can be used for transmit or
receive.
•
Link 1 - Working APS port, Link 2 - Protecting APS port
•
62.5 micron or 50 micron multi-mode fiber-optic cable
•
9.5 micron single-mode fiber-optic cable
•
Maximum 1 kilometers for multi-mode fiber-optic cable
•
Maximum 13 kilometers for single-mode fiber-optic cable
Table 2-35 LED description for ATM OC-12c line card
LED Description
Offline When lit, this amber LED on the left side of the line card indicates that
the line card is offline (powered off) but is ready for hot swap.
The Offline LED also is lit briefly during a reboot or reset of the RS
but goes out as soon as the Control Module discovers the line card.
Online When lit, this green LED indicates that the line card is online and is
ready to receive, process, and send packets if configured to do so.
Link 2Link 1
Link2
Offline
Online
Tx
Rx
ATM-OC-12c-SMFG8M-A12B9-02
Hot
Swap
Link1