Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
2-32 Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide
Hardware Overview Introduction
The following table lists the media specifications for the 1000Base-T line card.
The following table lists the pin assignments for the RJ-45 connector on the 1000Base-T and for the RJ-45 connector
on the network side of the segment cable.
Figure 2-19 shows the pin positions in the 1000Base-T connectors.
Figure 2-19 1000Base-T RJ-45 connector
Table 2-25 Connector specifications for 1000Base-T line card
Port type Specification
1000Base-T
•
802.3ab standard
•
RJ-45 connector wired as Media Data Interface Crossed
(MDIX); see Table 2-26 for pin assignments
•
EIA Category 5 unshielded twisted pair cabling
•
Maximum 100 meters (328 feet) segment length
Table 2-26 Pin assignments for 1000Base-T line card
Line Card RJ-45 Connector Pin Number RJ-45 Connector at Other
End of Segment
TXD and RXD (transmit and
receive data)
1 TXD and RXD
TXD and RXD 2 TXD and RXD
TXD and RXD 3 TXD and RXD
TXD and RXD 4 TXD and RXD
TXD and RXD 5 TXD and RXD
TXD and RXD 6 TXD and RXD
TXD and RXD 7 TXD and RXD
TXD and RXD 8 TXD and RXD
87654321