Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide 2-19
Introduction Hardware Overview
The following table lists the pin assignments for the RJ-45 connector on the 10/100Base-TX and for the RJ-45
connector on the network side of the segment cable.
Table 2-10 Connector specifications for 10/100Base-TX line card
Port type Specification
10Base-T
•
802.3 standard
•
RJ-45 connector wired as Media Data Interface Crossed
(MDIX); see Table 2-11 for pin assignments
•
EIA Category 3, 4, or 5 unshielded twisted pair cabling
•
Maximum 100 meters (328 feet) segment length
100Base-TX
•
802.3u standard
•
RJ-45 connector wired as Media Data Interface Crossed
(MDIX); see Table 2-11 for pin assignments
•
EIA Category 5 unshielded twisted pair cabling
•
Maximum 100 meters (328 feet) segment length
Table 2-11 Pin assignments for 10/100Base-TX line card
Line Card RJ-45 Connector Pin Number RJ-45 Connector at Other End of
Segment
RXD (receive data) 1 TXD (transmit data)
RXD (receive data) 2 TXD (transmit data)
TXD (transmit data) 3 RXD (receive data)
Unused 4 Unused
Unused 5 Unused
TXD (transmit data) 6 RXD (receive data)
Unused 7 Unused
Unused 8 Unused