Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide 2-17
Introduction Hardware Overview
DC Power Supply Specifications
Table 2-7 lists the physical specifications for the RS’s DC Power Supplies.
Table 2-8 lists the environmental specifications for the RS’s DC Power Supplies.
2.4.7 Switching Fabric Module (RS 8600 only)
On the RS 8600, the switching fabric is contained on a separate plug-in module. The RS 8600 has slots for two of these
modules. When two switching fabric modules are installed, the module in the slot labelled “Fabric 1” serves as the
primary switching fabric module, and the module in the slot labelled “Fabric 2” serves as a redundant switching fabric
module.
Figure 2-8 shows the front panel of the RS 8600 Switching Fabric module.
Figure 2-8 Front panel of RS 8600 Switching Fabric module
Table 2-7 Specifications for DC power supply
RS Switch
Router
Dimensions Weight Power
Output
Voltage Range
RS 8000 1.00" (L) x 7.70" (W) x 2.55" (H) 6.5 lbs. (2.95 kg) 300 W 36 to 72 V, 14 A @ 48 V
nominal
RS 8600 12.15" (L) x 7.70" (W) x 5.05" (H) 12.0 lbs. (5.45 kg) 600 W 36 to 72 V, 27 A @ 48 V
nominal
Table 2-8 Environmental specifications for DC power supply
Specification Measurement
Operating Temperature +5 to +40 °C (41 to 104 °F)
Non-operating temperature -30 to +73 °C (-22 to 164 °F)
Operating Humidity 15 to 90% (non-condensing)
G86-SWF
Switching Fabric
Active
Online
Swap
Hot
Offline