Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide Index-3
J
jumpers
L
L2 lookup table
L3 lookup tables
Layer-4
application switching
flow switching
layer-4 switching
LED, power supply
LEDs ,
10/100Base-TX , , ,
1000Base-LLX
1000Base-LX
1000Base-SX
100Base-FX
ATM OC-3c
ATM-OC12c
Dual HSSI
HSSI
MPLS line card
POS OC-12c
POS-OC3c
Quad Serial - C/CE
LFAP
line card, installation
line editing commands
load balancing
loading software from a TFTP server
loading software from BootP/TFTP server
loading software from the network
M
management
CLI
SNMP
traps
management platforms
managing software
MIB II
MIB II statistics
MIBs
MPLS ,
features
G8M-GBCMM-02
line card ,
MPLS activated Gigabit line card
MPLS line card LEDs
Multi Protocol Label Switching
multicast routing
DVMRP
GARP/GVRP
IGMP
N
NVRAM
O
OSPF
v2
overview
hardware
P
packing list
password
bypassing
Enable
User
passwords
persistence
port
1000-Mbps ,
dual serial
Gigabit ,
HSSI
port-based VLANs
POS OC-12c line cards
POS OC-3c line cards
power supply
power supply, AC, installation
power supply, DC, installation,
powering on
previous command
primary CM
protocol-based VLANs
protocols
bridging and VLAN
routing