Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
Index-2 Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide
active
DNS domain name and address
en0 Ethernet interface
saving
scratchpad
startup
trap target
viewing
configuration file annotations
Configure mode
configuring BootP/TFTP server
Control Module ,
changing mastership
fail over
fail over time
installation
IP addresses
messages
NVRAM
redundant
copy active to startup,
copy startup to scratchpad
Ctrl+z
D
date and time
DB-9 console port
DB-9 port
default baud rate
default name
DNS
DNS domain name
Dual HSSI line card
overview
dual serial port
DVMRP
E
E3 WIC
setting jumpers
en0 Ethernet interface
Enable mode
exit command
F
fail over
fail over time
fan module
features
flash RAM card
flow ACLs
layer-3
layer-4
flow switching
flow-based bridging
FPGA ,
FPGA code
functional layer terminology
G
GARP/GVRP
GBIC
components of
installation
removal
specification
GBICs
H
hard fail over
hardware
overview
specifications
hitless upgrade
HSSI port
I
if you forget your password
IGMP
improving SNMP security
installing GBICs
Internet address $
ip add route
IPX routing
default
RIP
SAP
IS-IS
ISO 7-layer model