Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
4-2 Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide
Powering on the RS 8000/8600 Initial Configuration
5.
When the software is fully booted, the following messages appears on the management console:
6.
As prompted, press Return (or Enter) to activate the Command Line Interface (CLI) on the console.
L2-Cache 256 KB, linesize 32, cache enabled.
Mounting 16MB external flash card . . . Done
Autoboot in 2 seconds - press ESC to abort and enter prom
using link: bootsource
link pointed at file:/pc-flash/boot/ros80/
source: file:/pc-flash/boot/ros80/
Loaded version file
Loading kernel (base 0x80001000, size 50592)
(base 0x8000d5a0, size 2803976)
100% - Image checksum validated
----------------------------------------------------------------------
RS 8000 System Software, Version 8.0.0.0
Copyright (c) 2000, Riverstone Networks
Processor: R7000, Rev 2.1, 280 MHz
System started on 2001-09-01 18:57:40
----------------------------------------------------------------------
2001-09-01 18:57:45 %SYS-I-FLASHCRD, Mounting 16MB Flash card
2001-09-01 18:57:53 %SYS-I-FLASHMNTD, 16MB Flash card mounted
2001-09-01 18:57:53 %SYS-I-INITSYS, initializing system RS 8000
2001-09-01 18:57:53 %SYS-I-DSCVMOD, discovered 'Control Module' module in slot CM
2001-09-01 18:57:58 %SYS-I-INITSLOTS, Initializing system slots - please wait
2001-09-01 18:58:07 %SYS-I-MODPROBE, Detecting installed media modules - please wait
...
Press RETURN to activate console...