Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
3-16 Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide
Installing the Hardware Hardware Installation
3.3.9 Installing ATM Physical Media Cards (PHYs)
The ATM multi-rate line card has two option slots available for Physical Layer (PHY) interface cards. One PHY card
can be installed into each available slot. You will need a #2 Phillips-head screwdriver to perform this procedure.
1.
Use the #2 Phillips-head screwdriver to loosen the two captive screws that hold the option slot cover
plate in place.
2.
Save the option slot cover plate.
3.
Insert the PHY card through the opening of the slot, and align the sides of the PHY card with the
guides in the option slot.
4.
Push the PHY card through the front of the line card until the 96-pin connector is firmly seated in
the connector at the back of the option slot.
5.
Fasten the PHY card to the front of the ATM line card with the two captive screws. Torque to 5 in-lb
(0.56 N-m).
Figure 3-12 Installing an ATM PHY card
ATM Board
Seat screws into
mounting holes,
then press PHY card
to fully engage connector
Phy Card
Guide Rails
PHY Bay