BOILER ELECTRONIC CONTROLLER USER MANUAL UPPER LED READOUT LED ICONS LOWER LED READOUT Page 1 / 7 Riverside Hydronics LLC • 3220 Galvez Dr • Fort Worth, Texas 7611 • 800-990-5918 34-80 04/2013
1. 1.1 DISPLAY AND INTERFACE KEYBOARD BUTTONS - Displays and modifies the temperature set points. In programming mode, it selects a parameter or confirms an operation. - Displays and modifies the energy saving (Night Time setback) settings. In programming mode, it browses the parameter codes or increases a displayed value. - Displays the working hours of the load relays. In programming mode, it browses the parameter codes or decreases a displayed value.
1.4 UPPER LED READOUT The default display of this readout is the temperature sensed at Probe 2, which is generally the supplied outlet water temperature. Probe 2 may display the tank stored water temperature, flue gas temperature, ambient temperature, remote tank or blended water temperature, etc., depending on the product and application. Refer to your specific product’s Installation and Maintenance Manual and the supplied wiring drawing.
. To exit push + or wait 15 seconds without pressing any buttons. Note: This device recognizes Sunday as the first day of the week and Saturday as the last. 1.7 TO SET THE ENERGY SAVING TIME (NIGHTIME SETBACK) 1. Push and hold the displayed. 2. Use the or button for more than 3 seconds and the first parameter of the energy saving will be buttons to browse them. 3. To change a value, push the 4. To exit from the menu, press 1.8 button followed by and or and then the button again.
To program different set points proceed as described below: button, the Upper LED readout will display the “St1” parameter name, while the Lower LED 1. Press the readout will show the corresponding value. 2. Use the or buttons to cycle the Upper LED readout through the St1, St2 and St3 parameter names. On some products St2 and St3 will be located in the PR2 menu and require password access. button to modify a parameter value. The value starts flashing in the Lower LED readout. 3. Press the 4.
2.4 ASSIGNING TEMPTRAC ADDRESS FOR MODBUS-RTU The first step to interfacing a BAS (Building Automation Control) with a boiler or group of boilers will be the assignment of the address number for each boiler. 1. Enter the Programming mode by pressing the Set and DOWN key for 3s. (lead with the SET key) 2. Press the DOWN key. 3. Select “Pr2” – “PAS” parameter and press the “SET” key. 4. The value “0 - -” with a flashing zero is displayed. Adr 1 5.
3.1 AUDIBLE ALARM The TempTrac audible alarm is activated each time a connected alarm condition occurs. The following are representative alarm conditions that may be connected to and activate the TempTrac audible alarm (some alarms may be connected to and operate separately from the TempTrac on some products).
