Technical data

Page 24/ 24 34-81 10/2013
13.3 ALARM RECOVERY
1. Probe alarms: “P1”, “P2”, and “P3”; automatically stop a few seconds after the probe returns to normal operation.
Check connections before replacing the probe.
2. Temperature alarms “HA” and “LA” automatically stop as soon as probe 1 temperature returns to AFH degrees
below or above the alarm value respectively.
3. The digital input 1 alarm recovers automatically when the need for output 1 stops. Manual recovery is required
when the condition of Input 1 is removed, but the need for output 1 is still present. Pressing any button will reset
this condition.
4. The digital input 2 & 3 alarms recover when condition(s) listed above are normalized and any button is pressed.
5. RTC alarm stops after programming the real time clock.
6. RTF alarm requires the replacement of the TempTrac® device.
For additional information, contact the Riverside Hydronics Customer Service department at
800-990-5918.