Specifications

Riverside Hydronics
®
, LLC WWW.RIVERSIDEHYDRONICS.COM 34-151 06/2014
3220 Galvez Avenue - Fort Worth, Texas 76111 - Tel [phone] Page | 2
Caution and Mounting of Control_________________________________________________ 2
Cabinet Details ______________________________________________________________ 3
Wiring of Control Panel ________________________________________________________ 4
Wiring RS485 Communication Bus _______________________________________________ 5
Wiring External Set Point and Remote Proving ______________________________________ 6
Wiring Remote Equipment and Remote Alarm ______________________________________ 7
Wiring System and Outdoor Sensor _______________________________________________ 8
TempTrac Control Module for non-Riverside Hydronics boilers __________________________ 9-10
Specifications ________________________________________________________________ 11
WARNING: Improper installation, operation, adjustment, alteration, service or maintenance can cause damage
to the device, property damage, personal injury, exposure to hazardous material or death. Refer to the
information contained in this manual.
WARNING: Do not use this electronic control as a primary limit control. Other limit and operating controls that
are intended and certified as safety controls and limits must remain in or be added to the control circuit. Use of
this control as a primary limit control can cause property damage, personal injury, exposure to hazardous
material or death.
NOTE: It is your responsibility to ensure this control is installed according to all applicable codes and standards.
NOTE: Other than externally accessible fuse(s), there are no user serviceable parts. Refer all other service
requirements to a qualified agent. Service by other than a qualified agent voids the warranty.
WARNING: Do not attempt to service this control. Such an attempt can cause damage to the device, property
damage, personal injury, exposure to hazardous material or death.
Placement of the controls is important. To enable proper wiring during rough in, select an appropriate
location for the controls early in the construction process. Consider the following:
• Keep dry. Avoid potential leakage onto the control. RH 80% to 88°F (31°C), down to 50% from 104
to 122°F (40 to 50°C). Non-condensing environment.
• Do not expose to temperatures beyond 32-122°F (0-50°C).
• Provide adequate ventilation.
• Keep away from equipment, appliances or other sources of electrical interference.
• Provide easy access for wiring, viewing, and adjusting the display screen.
• Mount approximately 5 ft. (1.5 m) off the finished floor.
• Mount the control enclosure as close to the equipment being controlled as possible.
• Mount the enclosure to a solid backing.
TABLE OF CONTENT
S
LOCATION AND MOUNTI
N
G
INSTALLATION NOTES AND WARNING
S