Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
7
Operator's Manual
LOCKDOWN WIDE 1-MAN Ladder Stand
ASSEMBLY INSTRUCTIONS
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus
one turn of a wrench only! This will temporarily hold the
lock- nut on the bolt while helping alignment of all parts!
After all parts are assembled together, all nut and bolt combi-
nations must be completely tightened.
All assembly must be done in this order at ground
level before uprighting.
Do not remove labels/warnings from product, they are
there for your safety.
Recommended for adult use only.
FIGURE 1
FIGURE 2
NOTE: When selecting a tree to install the treestand
in, never use a treestand on a dead leaning,
diseased or loose barked tree, or a utility pole.
Always avoid electrical power lines.
1. Assemble the top tree blade (19) to the two seat side
rails (9) using four 1/4-20 x 1-1/2 IN bolts (39) and
four 1/4-20 IN nuts (44). SEE FIGURE 1
19
9
44
39
12
42
9
25
44
11
42
2. Attach the left armrest (11) and right armrest (12)
to the outer edge of the seat rails (9) using two
1/4-20 x 3-1/4 IN bolts (42), two yellow washers (25)
and two 1/4-20 IN nuts (44) for each armrest. SEE
FIGURE 2
NOTE: To verify that you have the correct armrests
attached to the seat rails, the slotted plates on the
armrest should be outward facing in orientation.
NOTE: It is important to follow the placement of all
hardware. Bolts should always be facing outwards
(away from the user) when being used in a location
where clothing can be easily caught on.