Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
14
Operator's Manual
LOCKDOWN WIDE 1-MAN Ladder Stand
FIGURE 16
FIGURE 16A FIGURE 16B
FIGURE 16C
STABILIZER BAR RATCHET STRAP 50
23. Attach the straps of the stabilizer bar ratchet assembly (50)
to the stabilizer bar bark biting plate, which is part of the
stabilizer bar (1).
a. Feed the sewn loop of the long strap through either side
slot in the bark biting plate and then feed the loose end
through the sewn loop. SEE FIGURES 16A AND 16B
b. Pull tight, forming a cinch knot. This permanently
attaches the long strap to the stabilizer bar. SEE FIGURES
16B AND 16C
c. Feed the sewn loop of the ratchet buckle strap through
the opposite side slot in the bark biting plate and then feed
the ratchet buckle through the sewn loop.
d. Pull tight, forming a cinch knot. This permanently attaches
the ratchet buckle strap to the stabilizer bar.
SEE FIGURE 16C.
LARGE RATCHET STRAPS 48
The large ratchet straps (48) that secure the platform and tree
blades to the tree will be used later during the Setup and Use
Instructions, after uprighting the stand.
NOTE: Make sure to bring ratchet straps up with you in a pocket.
Never carry in your hands!
FIGURE 15C
FIGURE 15B FIGURE 15A
LONG CRISSCROSS RATCHET STRAPS 49
22. Attach the two long straps of the criss-cross ratchet
straps (49) to the rear of the foot platform (2) near the
lower tree blade.
a. Wrap sewn loop of each strap around each side of the
platform and feed the loose end through the sewn loop.
SEE FIGURES 15A AND 15B
b. Pull tight, forming a cinch knot. This permanently
attaches the long straps to the platform. SEE FIGURES 15B
AND 15C
NOTE: The ratchet portion of the long straps will be used
later during Setup and Use Instructions.
49
2
49
2
49
2
50
1
50
1
1
50
FIGURE 15