Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

Operator's Manual

LOCKDOWN 2-MAN Ladder Stand

ASSEMBLY INSTRUCTIONS

IMPORTANT ASSEMBLY TIP:

Do not tighten any nut and bolt combinations completely

until all parts are assembled together! Finger tighten plus

one turn of a wrench only! This will temporarily hold the

lock- nut on the bolt while helping alignment of all parts!

After all parts are assembled together, all nut and bolt combi-

nations must be completely tightened.

All assembly must be done in this order at ground

level before uprighting.

Do not remove labels/warnings from product, they are

there for your safety.

Recommended for adult use only.

FIGURE 1

FIGURE 2

2. With the platform (26) assembled, attach the j-tubes (5) and

lower tree blade (18) with fourteen 1/4 -20 X 3 IN bolts (35) and

fourteen 1/4-20 nuts (36). SEE FIGURE 2.

NOTE: When selecting a tree to install the treestand

in, never use a treestand on a dead leaning, diseased

or loose barked tree, or a utility pole. Always avoid

electrical power lines.

1. Join the two platform halves (9) using two 1/4 -20 X 2-1/4 IN

bolts (33) and two 1/4-20 nuts (36) by aligning the holes in the

edges of the platform, using the fasteners as shown in FIGURE 1.

Mesh hidden

for clarity