Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

Operator's Manual

LOCKDOWN 2-MAN Ladder Stand

FIGURE 14

FIGURE 14A FIGURE 14B

FIGURE 14C

STABILIZER BAR RATCHET STRAP 41

18. Attach the straps of the stabilizer bar ratchet assembly (41)

to the stabilizer bar bark biting plate, which is part of the

stabilizer bar (1).

a. Feed the sewn loop of the long strap through either side

slot in the bark biting plate and then feed the loose end

through the sewn loop. SEE FIGURES 14A AND 14B.

b. Pull tight, forming a cinch knot. This permanently

attaches the long strap to the stabilizer bar. SEE FIGURES

14B AND 14C.

c. Feed the sewn loop of the ratchet buckle strap through

the opposite side slot in the bark biting plate and then feed

the ratchet buckle through the sewn loop.

d. Pull tight, forming a cinch knot. This permanently attaches

the ratchet buckle strap to the stabilizer bar.

SEE FIGURE 14C.

LARGE RATCHET STRAPS 39

The large ratchet straps (39) that secure the platform and tree

blades to the tree will be used later during the Setup and Use

Instructions, after uprighting the stand.

NOTE: Make sure to bring ratchet straps up with you in a pocket.

Never carry in your hands!

FIGURE 13C

FIGURE 13B FIGURE 13A

LONG CRISSCROSS RATCHET STRAPS 40

17. Attach the two long straps of the criss-cross ratchet straps (40)

to the rear of the foot platform (9) near the lower tree blade.

a. Wrap sewn loop of each strap around each side of the

platform and feed the loose end through the sewn loop.

SEE FIGURES 13A AND 13B.

b. Pull tight, forming a cinch knot. This permanently

attaches the long straps to the platform. SEE FIGURES 13B

AND 13C.

NOTE: The ratchet portion of the long straps will be used

later during Setup and Use Instructions.

FIGURE 13