Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
12
Operator's Manual
LOCKDOWN 2-MAN Ladder Stand
FIGURE 1A
bottom
ladder
section
middle
ladder section
with stabilizer
slot
middle
ladder
section
top
ladder
section
6
7
17
8
FIGURE 11
FIGURE 12
15. Slide the stabilizer bar (1) into the stabilizer support tube (2)
and secure using a 1/4-20 x 1-3/4 IN wing screw (29) and a
wing nut (28). Make sure the screw passes through the support
tube and the stabilizer bar at the appropriate hole to achieve
the desired distance from the tree. Adjustment in length may
be needed when ladder is uprighted later in the Setup and Use
Instructions. SEE FIGURE 12.
16. Connect the stabilizer bar assembly (1) through the middle
ladder section with stabilizer slot (17). These components will
be connected using a 1/4-20 x 1-3/4 IN wing screw (29) and
one wing nut (28). SEE FIGURE 12.
NOTE: Treestand should ALWAYS be fully assembled on the
ground prior to mounting it in the tree.
14. Ladder sections are assembled on the ground in the following
order: bottom ladder section (8), middle ladder section with
stabilizer slot (17), middle ladder section (7), and the top ladder
section (6) with the treestand top assembly. Connect all sections
together using the six silent knob assemblies (21).
SEE FIGURES 11 AND 11A.
ground
2
29
1
29
28
17
28
* Additional
sections of ladder
hidden for clarity
28
7
6
17
8