Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

Operator's Manual

LOCKDOWN 2-MAN Ladder Stand

FIGURE 9

FIGURE 10

10. The shooting rail assembly connects to the armrest as shown in

FIGURE 9. Use the following hardware: two 1/4-20 X 3-1/4 IN

bolts, four yellow plastic washers (20), two yellow spacers (23)

and two 1/4-20 nuts (36).

NOTE: The shooting rail is designed to have multiple

congurations. Adjustments can be made to the height by

loosening the knob in the slotted-plate on the armrests, and

moving it either upwards or downward until desired height

is achieved. Once location has been reached re-tighten the

knob to create a rm seat for the shooting rail to rest on. To

move the shooting rail closer to you or further away, use the

three holes drilled into the end of the shooting rail to place it

in the desired location.

FIGURE 9A

11. Take top ladder section (6) and attach to j-tubes (5) with two

1/4-20 X 1-3/4 IN bolts (30) and two 1/4-20 nuts (36) as shown

in FIGURE 10.

12. After top ladder section (6) has been assembled and secured,

take platform braces (3) and attach to outer edge of j tubes (5)

with two 1/4-20 X 2-1/4 IN bolts (33), two yellow plastic washers

(20) and two 1/4-20 nuts (36). SEE FIGURE 10.

13. Take other end of platform braces (3) and attach to outer edge

of top ladder section (6) with two 1/4-20 X 2-1/4 IN bolts (33), two

yellow plastic washers (20) and two 1/4-20 nuts (36).

SEE FIGURE 10.