Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
7
Operator's Manual
LOCKDOWN 21 1-MAN Ladder Stand
ASSEMBLY INSTRUCTIONS
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus one
turn of a wrench only! This will temporarily hold the lock nut
on the bolt while helping alignment of all parts! After all parts
are assembled together, all nut & bolt combinations must be
completely tightened.
All assembly must be done in this order at ground
level before uprighting.
Do not remove labels/warnings from product, they are
there for your safety.
Recommended for adult use only.
34
26
4
1
23
29
34
1
2
3
FIGURE 1
FIGURE 2
NOTE: When selecting a tree to install the treestand in, never use
a treestand on a dead leaning, diseased or loose barked tree, or
a utility pole. Always avoid electrical power lines.
1. Slide the TearTu
™
mesh shelf (23) onto the straight ends of the
J-tubes (1). Slide the lower tree blade (4) into the J-tubes and
secure with four 1/4-20 X 1-1/2 IN bolts (26) and 1/4 IN ange
locknuts (34). SEE FIGURE 1.
NOTE: TearTu
™
mesh shelf must be slid far enough down the
J-tubes to expose the lower tree blade mounting holes.
2. Tighten hardware securely at this time. Be sure not to over tighten
or crush tubing. Slide the TearTu
™
mesh shelf (23) all the way
back towards the tree blade (4). Mesh is intended to cover the
previously tightened hardware.
3. Attach the front platform (2) and rear platform (3) to the two
J-tubes (1) using twelve 1/4-20 X 3 IN bolts (29) and 1/4 IN ange
locknuts (34). SEE FIGURE 2.
NOTE: The rounded corners of the front and rear platform need
to be oriented so that they are on the outside corners of the
platform. The rear platform has additional vertical holes on the
outer edge of the platform.