Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
12
Operator's Manual
LOCKDOWN 21 1-MAN Ladder Stand
46
4
46
4
46
4
FIGURE 11
24. Attach stabilizer support tube (20) to the lowest middle ladder
section (15) using 1/4-20 x 2 1/4 IN wing screw (33) and wing nut
(36). SEE FIGURE 11.
NOTE: Mounting hole is located just below top ladder rung on
the middle ladder section.
25. Slide the bark biting stabilizer bar (21) into the stabilizer support
tube (20) and secure using 1/4-20 x 1 3/4 IN wing screw (32) and
wing nut (36). Make sure screw passes through support tube
and stabiizer bar at appropriate hole to achieve desired distance
from tree. Adjustment in length may be needed when ladder is
uprighted later in the Setup and Use instructions. SEE FIGURE11.
NOTE: Treestand should ALWAYS be fully assembled on the
ground prior to mounting it in the tree.
NOTE: Uprighting of the stand may be easier with the stabilizer
bar not attached to the ladder. If removed, refer back during
setup.
36 33
32
36
20
21
FIGURE 12
FIGURE 12A FIGURE 12B
FIGURE 12C
26. Attach the two long straps of the criss cross ratchet straps (46) to
the rear of the J-tubes near the lower tree blade.
a. Wrap sewn loop of each strap around the J-tubes on each side
of the platform and feed the loose end through the sewn loop.
SEE FIGURES 12A & 12B.
b. Pull tight, forming a cinch knot. This permanently attaches the
long straps to the platform. SEE FIGURES 12B & 12C.
NOTE: The ratchet portion of the long straps will be used later
during the Setup and Use instructions.