Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

Operator's Manual

LOCKDOWN 21 1-MAN Ladder Stand

FIGURE 9

FIGURE 10

FIGURE 9

22. Ladder sections are assembled on the ground in the following

order: bottom ladder section (16); three middle ladder sections

(15); top ladder section (14) and the treestand top. SEE FIGURE

10.

23. With all sections assembled together on ground, secure all

sections together using twelve silent knobs (40).

18. Attach one shooting rail part A (17) to each end of shooting rail

part B (18) using two 1/4-20 X 1-1/4 IN bolts (25) and 1/4 IN ange

locknuts (34). SEE FIGURE 9.

19. Slide the ends of the shooting rail (17,18) onto the shooting rail

pegs on the right and left armrests. SEE FIGURE 9.

20. Attach the footrest (19) to the front platform (2) using two 1/4-20

X 2-1/2 IN (28), six yellow M6 plastic washers (38) and two 1/4 IN

ange locknuts (34).

NOTE: Hardware should be arranged from the outside to the

inside as follows: 1/4-20 X 2-1/2 IN bolt (28), yellow washer (38),

footrest (19), yellow washer (38), front platform (2), yellow

washer (38), 1/4 IN locknut (34).

NOTE: Footrest is intended to be able to pivot from the hidden

position between the front and rear platforms and the use

position swung out in front of the platform.

21. Tighten all nut and bolt combinations completely at this time.

Be sure not to over tighten or crush tubing when tightening.