Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

Operator's Manual

LOCKDOWN 21 1-MAN Ladder Stand

FIGURE 8

FIGURE 7

14. Attach the seat (11) to the seat mounting brackets of the rear seat

supports (6,7) using two 1/4-20 X 2 IN bolts (27), four yellow M6

plastic washers (38), two yellow M6 plastic spacers (39) and two

1/4 IN ange locknuts (34). SEE FIGURE 7.

NOTE: Hardware should be arranged from the outside to the

inside as follows: 1/4-20 X 2 IN bolt (27), yellow washer (38), seat

mounting bracket, yellow spacer (39), seat (11), yellow washer

(38), 1/4 IN ange locknut (34).

15. Slide top ladder section (14) into J-tubes (1) and secure with two

silent knobs (40). These silent knob assemblies consist of a simple

threaded knob with carriage bolt. Thread the knob onto carriage

bolt, only about 2 turns. Insert the head of carriage bolt into the

large end of the key hole type opening in ladder pocket and slide

the square “block” portion of carriage bolt head down into the

slot. Doing this will capture the square “block” portion of carriage

bolt and hold it in place. Tighten the knob by hand until tight

which will draw the two ladder sections together and eliminate

any slack between the ladder sections. SEE FIGURE 8.

16. Attach the bent end of the two platform braces (13) to the outside

edges of the top ladder section (14) using two 5/16-18 x 2-1/4 IN

bolt (30) and 5/16 IN locknuts (35). SEE FIGURE 8.

17. Attach the free ends of the two platform braces (13) to the J-tubes

(1) below the rear platform using two 5/16-18 x 2-1/4 IN bolts (30)

and 5/16 IN locknuts (35).

SEE FIGURE 8.

FIGURE 7A