Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
7
Operator's Manual
LOCKDOWN 21 2-MAN Ladder Stand
ASSEMBLY INSTRUCTIONS
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus one
turn of a wrench only! This will temporarily hold the lock nut
on the bolt while helping alignment of all parts! After all parts
are assembled together, all nut & bolt combinations must be
completely tightened.
All assembly must be done in this order at ground
level before uprighting.
Do not remove labels/warnings from product, they are
there for your safety.
Recommended for adult use only.
28
34
2
3
1
4
24
35
1
31
FIGURE 1
FIGURE 2
NOTE: When selecting a tree to install the treestand in, never use
a treestand on a dead leaning, diseased or loose barked tree, or
a utility pole. Always avoid electrical power lines.
1. Attach the front platform (3) and rear platform (2) to the two
J-tubes (1) using twelve 1/4-20 x 3 IN bolts (28) and 1/4 IN ange
locknuts (34). SEE FIGURE 1.
NOTE: Angled corners of front platform (3) must be oriented
towards the bent ends of the J-tubes (1). The bolt holes on the
outside edge of the rear platform (2) must be oriented towards
the front platform (3).
2. Slide the TearTu
™
mesh shelf (24) onto the straight ends of the
J-tubes (1). Attach the lower tree blade (4) to the J-tubes with
two 5/16 x 18 x 3-1/4 IN bolts (31) and 5/16 IN locknuts (35). SEE
FIGURE 2.