Installation Instructions

Operator's Manual

LOCKDOWN 21 2-MAN Ladder Stand

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

FIGURE 12

FIGURE 12A FIGURE 12B

FIGURE 12C

24. Attach the straps of the stabilizer bar ratchet assembly (47) to the

stabilizer bar bark biting plate.

a. Feed the sewn loop of the long strap through either side slot

in the bark biting plate and then feed the loose end through the

sewn loop. SEE FIGURES 12A & 12B.

b. Pull tight, forming a cinch knot. This permanently attaches the

long strap to the stabilizer bar. SEE FIGURES 12B & 12C.

c. Feed the sewn loop of the ratchet buckle strap through the

opposite side slot in the bark biting plate and then feed the

ratchet buckle through the sewn loop.

d. Pull tight, forming a cinch knot. This permanently attaches the

ratchet buckle strap to the stabilizer bar. SEE FIGURE 12C.

25. Attach removable seat pad (21) to the metal seat frame by sliding

seat frame into pocket. Wrap buckle straps around seat frame and

secure together. Pull straps tight so seat is not loose.

26. Attach removable backrest pad (22) to the TearTu

™

mesh backrest

with hook and loop attachment strips on the top and bottom of

the back of mesh and the left and right sides of the front of the

mesh.

NOTE: The large ratchet straps (45) that secure the platform and

tree blades to the tree will be used later during the Setup and

Use instructions, after uprighting the stand.

NOTE: Make sure to bring ratchet straps up with you in a pocket.

Never carry in your hands!

FIGURE 11C

FIGURE 11B FIGURE 11A

23. Attach the two long straps of the criss cross ratchet straps (46) to

the rear of the J-tubes near the lower tree blade.

a. Wrap sewn loop of each strap around the J-tubes on each side

of the platform and feed the loose end through the sewn loop.

SEE FIGURES 11A & 11B.

b. Pull tight, forming a cinch knot. This permanently attaches the

long straps to the platform. SEE FIGURES 11B & 11C.

NOTE: The ratchet portion of the long straps will be used later

during the Setup and Use instructions.

FIGURE 11