Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
11
Operator's Manual
LOCKDOWN 21 2-MAN Ladder Stand
FIGURE 10
FIGURE 9
36 33
32
36
19
20
40
15
14
14
14
13
21. Attach stabilizer support tube (19) to the lowest middle
ladder section (14) using 1/4-20 x 2-1/4 IN wing screw
(33) and wing nut (36). SEE FIGURE 10.
NOTE: Mounting hole is located just below top ladder
rung on the middle ladder section.
22. Slide the bark biting stabilizer bar (20) into the stabilizer
support tube (19) and secure using 1/4-20 x 1-3/4 IN
wing screw (32) and wing nut (36). Make sure screw
passes through support tube and stabiizer bar at
appropriate hole to achieve desired distance from tree.
Adjustment in length may be needed when ladder is
uprighted later in the Setup and Use instructions. SEE
FIGURE 10.
NOTE: Treestand should ALWAYS be fully assembled on
the ground prior to mounting it in the tree.
NOTE: Uprighting of the stand may be easier with the
stabilizer bar not attached to the ladder. If removed,
refer back during setup.
19. Ladder sections are assembled on the ground in the following
order: bottom ladder section (15); three middle ladder sections
(14); top ladder section (13) and the treestand top. SEE FIGURE 9.
20. With all sections assembled together on ground, secure all
sections together using twelve silent knobs (40).