Installation Instructions

Operator's Manual

LOCKDOWN 21 2-MAN Ladder Stand

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

FIGURE 8

FIGURE 7

10. Slide top ladder section (13) into J-tubes (1) and secure with two

silent knobs (40). These silent knob assemblies consist of a simple

threaded knob with carriage bolt. Thread the knob onto carriage

bolt, only about 2 turns. Insert the head of carriage bolt into the

large end of the key hole type opening in ladder pocket and slide

the square “block” portion of carriage bolt head down into the

slot. Doing this will capture the square “block” portion of carriage

bolt and hold it in place. Tighten the knob by hand until tight

which will draw the two ladder sections together and eliminate

any slop between the ladder sections. SEE FIGURE 7.

11. Insert bent end of one platform brace (12) into the lower end of

one ladder hand rail (11). Attach connection point to the outside

edge of the top ladder section (13) using one 5/16-18 x 2-1/2 IN

bolt (30) and 5/16 IN locknut (35). Make sure bolt passes through

ladder hand rail, platform brace and top ladder section. SEE

FIGURE 7.

12. Repeat previous step for opposite platform brace (12) and ladder

hand rail (11). SEE FIGURE 7.

13. Attach the free end of both ladder hand rails (11) to the J-tubes

(1) just in front of the front platform using two 5/16-18 x 2-1/2 IN

bolts (30) and 5/16 IN locknuts (35).

SEE FIGURE 7.

14. Attach the free end of both platform braces (12) to the J-tubes (1)

below the rear platform using two 5/16 x 18 x 2-1/4 IN bolts (29)

and 5/16 IN locknuts (35). SEE FIGURE 7.

15. Attach one shooting rail part A (16) to each end of shooting rail

part B (17) using two 1/4-20 X 1-1/4 IN bolts (25) and

1/4 IN ange locknuts (34). SEE FIGURE 8.

16. Slide the ends of the shooting rail (16,17) onto the shooting rail

pegs on the right and left armrests. SEE FIGURE 8.

17. Attach the footrest (18) to the front platform (3) using two 1/4-20

x 2-1/2 IN (27), six yellow M6 plastic washers (38) and two 1/4 IN

ange locknuts (34).

NOTE: Hardware should be arranged from the outside to the

inside as follows: 1/4-20 x 2-1/2 IN bolt (27), yellow washer (38),

footrest (18), yellow washer (38), front platform (3), yellow

washer (38), 1/4 IN locknut (34).

NOTE: Footrest is intended to be able to pivot from the hidden

position between the front and rear platforms and the use

position leaning against the ladder hand rails.

18. Tighten all nut and bolt combinations completely at this time. Be

sure not to over tighten or crush tubing when tightening.