Operator's Manual WE ARE HUNTERS LOCKDOWN™ 21 2-MAN Ladder Stand MODEL RE650 Maximum Height 21' to shooting rail Maximum Field Rating 500 lbs; no more than 300 lbs per person. Tree Diameter Range 12" to 20" Wear Your Harness! PRODUCT MEETS INDUSTRY STANDARDS RECOGNIZED BY Get parts online at www.HuntRiversEdge.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand INTRODUCTION Rivers Edge® Treestands are engineered with you the hunter in mind. We appreciate your purchase of one of our world class treestands. Follow these few simple instructions and your stand will provide you many years of trouble-free pleasure. Instructions should be kept in a safe place and reviewed at least annually.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand STOP READ AND UNDERSTAND THE FOLLOWING WARNINGS BEFORE ASSEMBLY MODEL RE650 MAXIMUM USE HEIGHT - 21' TO SHOOTING RAIL MAXIMUM OCCUPANCY - TWO (2) TOTAL WEIGHT LIMIT - 500 LB (300 lb Per Person Max) TREE DIAMETER RANGE - 12” TO 20” WARNING This product carries strict height and weight restrictions. Do Not use this product if you exceed the total weight limit. Please note that the total weight limit includes the user(s) and their equipment.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand WARNING INSPECTION AND MAINTENANCE Always lean forward as you climb and attach your harness to the tree before securing the platform to the tree and stepping onto the platform. BEFORE EACH USE PERFORM THE FOLLOWING: Never exceed the stated maximum use height. • Inspect all webbing, rope, cord, and strap assemblies for wear or damage.
Bolts shown are for size reference. Extra hardware may be included in the parts bag.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand ASSEMBLY INSTRUCTIONS IMPORTANT ASSEMBLY TIP: Do not tighten any nut and bolt combinations completely until all parts are assembled together! Finger tighten plus one turn of a wrench only! This will temporarily hold the lock nut on the bolt while helping alignment of all parts! After all parts are assembled together, all nut & bolt combinations must be completely tightened. All assembly must be done in this order at ground level before uprighting.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand 26 34 5 FIGURE 3 29 6 3. Attach the two rear seat supports (6) to the underside of the rear platform (2) using four 5/16 x 18 x 2-1/4 IN bolts (29) and 5/16 IN locknuts (35). SEE FIGURE 3. 35 2 4. Attach the upper tree blade (5) to the lower set of bolt holes on the rear seat supports (6) using four 1/4-20 X 1-1/2 IN bolts (26) and 1/4 IN flange locknuts (34). SEE FIGURE 3. 26 6 34 7 23 5.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand 31 8 37 35 7. Attach the top of the right armrest (8) and the top of the left armrest (9) to the rear seat supports (6) using two 5/16 x 18 x 3-1/4 IN bolts (31), 5/16 IN washers (37) and 5/16 IN locknuts (35). Make sure that the seat posts are pointing inwards. SEE FIGURE 5. FIGURE 5 6 NOTE: Make sure that the armrests are attached to the second holes above the upper tree blade frame.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand 10. Slide top ladder section (13) into J-tubes (1) and secure with two silent knobs (40). These silent knob assemblies consist of a simple threaded knob with carriage bolt. Thread the knob onto carriage bolt, only about 2 turns. Insert the head of carriage bolt into the large end of the key hole type opening in ladder pocket and slide the square “block” portion of carriage bolt head down into the slot.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand 19. Ladder sections are assembled on the ground in the following order: bottom ladder section (15); three middle ladder sections (14); top ladder section (13) and the treestand top. SEE FIGURE 9. FIGURE 9 20. With all sections assembled together on ground, secure all sections together using twelve silent knobs (40). 13 40 14 14 14 15 21.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand 46 23. Attach the two long straps of the criss cross ratchet straps (46) to the rear of the J-tubes near the lower tree blade. 4 FIGURE 11B FIGURE 11 FIGURE 11A 4 a. Wrap sewn loop of each strap around the J-tubes on each side of the platform and feed the loose end through the sewn loop. SEE FIGURES 11A & 11B. b. Pull tight, forming a cinch knot. This permanently attaches the long straps to the platform. SEE FIGURES 11B & 11C.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand STOP READ AND UNDERSTAND THE FOLLOWING WARNINGS BEFORE SETUP AND USE WARNING Double check assembly steps to be certain you have correctly assembled this product. Study your new stand to become familiar with all of its features and design. At ground level, following provided use instructions, practice attaching stand to tree and removing stand from tree. Practice sitting, standing, and using this product before attaching overhead.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand SETUP AND USE INSTRUCTIONS During installation and removal of ladder treestands, you must always and properly use the included Full Body Harness (Fall Arrest System). Refer to the Full Body Harness instructions included with this product for proper use. 1. Select a straight, healthy tree. Do Not attempt to install on a tree that is not healthy. 2.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand 10. Locate the two ratchet portions with S-hooks for the criss cross straps (46). a. With one ratchet portion of the criss cross strap (46) now in hand, feed one long strap hanging down from platform through the center slot of ratcheting mechanism and back around through tightening lever. SEE FIGURES 15A & 15B. b.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand FINISHED LADDER REMOVABLE VINYL DIPPED SHOOTING RAIL FOLD-AWAY VINYL DIPPED FOOTREST LADDER HAND RAIL LARGE RATCHET STRAPS TEARTUFF™ MESH STORAGE SHELF LONG CRISS CROSS RATCHET STRAPS SILENT KNOB ASSEMBLIES STABILIZER BAR RATCHET STRAP OCTAGONAL LADDER TUBING BARK BITING STABILIZER BAR 16 Check for parts online at www.HuntRiversEdge.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand NOTES Check for parts online at www.HuntRiversEdge.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand ILLUSTRATED PARTS BREAKDOWN 6 31 42 37 22 34 21 23 35 7 43 31 26 5 41 34 8 MESH HIDDEN FOR CLARITY 26 35 39 3 2 18 27 38 30 10 35 39 29 13 28 25 17 35 16 34 34 30 38 38 35 9 49 24 31 1 35 4 34 36 29 35 20 35 12 11 19 32 33 30 14 40 15 18 Check for parts online at www.HuntRiversEdge.
Operator's Manual LOCKDOWN 21 2-MAN Ladder Stand PARTS LIST ITEM # PART # DESCRIPTION QTY.
by WE ARE HUNTERS Rivers Edge® Treestands, Inc. Phone: 800-450-EDGE (3343) 1160 Eighth Avenue, PO Box 755 Fax: 715-822-2124 Cumberland, WI 54829 Email: info@huntriversedge.com *All weights, specifications and features are approximate and are subject to change without notice. Due to continuous product improvements, product images may not be exact. Warning labels in some product images may have been removed for photography purposes only. Props shown in photos not included.
