Installation Instructions

Operator's Manual
18' 2-Man Ladder Stand
Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
6
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus one
turn of a wrench only! This will temporarily hold the lock nut
on the bolt while helping alignment of all parts! After all parts
are assembled together, all nut & bolt combinations must be
completely tightened.
ASSEMBLY INSTRUCTIONS
All assembly must be done in this order at ground
level before uprighting.
Do not remove labels/warnings from product, they
are there for your safety.
Recommended for adult use only.
1. Attach the foot platform (10) to the lower portion of the
two platform frame tubes (6) using four 5/16-18 x 2-1/4 IN
bolts (20) and locknuts (21). SEE FIGURE 1.
NOTE: Rounded corners of foot platform must be oriented
back, towards the platform frame tubes.
2. Attach the seat platform (12) to the upper portion of the
two platform frame tubes (6) using four 5/16-18 x 2-1/4 IN
bolts (20) and locknuts (21). SEE FIGURE 2.
NOTE: Rounded corners of seat platform must be oriented
forward, towards the foot platform.
3. Attach the two side frame tubes (8) to the underside of the
seat platform (12) using four 5/16-18 x 2-1/4 IN bolts (20)
and locknuts (21). SEE FIGURE 2.
10
6
20
21
12
8
6
20
21
FIGURE 1
FIGURE 2