Installation Instructions

Operator's Manual

18' 2-Man Ladder Stand

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

FIGURE 10A FIGURE 10B FIGURE 10C

FIGURE 10

FIGURE 9

17. Attach the two long ends of the 16’ criss-cross straps (27) to

the platform frame tubes (6) near the tree blade. These long

stabilizer straps should be attached by pulling the free end of

the strap through the loop end of the strap to create a cinch

knot around the frame tube. SEE FIGURE 10.

18. To aid in the ease of installation, pre-attach each end of

the 6’ ratchet strap (26) to each side of the platform frame

tubes (6) between the 16’ criss cross straps (27) and the tree

blade. Use the same method as above. SEE FIGURES 10A,

10B & 10C. This way each end of the main ratchet strap is

pre-attached before the stand is lifted from the ground.

19. Attach removable seat pad (13) to the metal seat frame

by wrapping buckle straps around seat frame and secure

together. Pull straps tight so seat is not loose.

20. Attach removable backrest and shooting rail pads (16) to

the backrest tube (15) and the shooting rail tube (7) with

hook and loop attachment strips on the pads.

14. Attach stabilizer support tube (2) to the slotted piece on

the middle ladder section (22) using a lockpin (18).

SEE FIGURE 9.

15. Slide the stabilizer bar (1) into the stabilizer support tube (2)

and secure using a lockpin (18). Make sure lockpin passes

through support tube and stabilizer bar at appropriate hole

to achieve desired distance from tree. Adjustment in length

may be needed when ladder is uprighted later in the Setup

and Use instructions. SEE FIGURE 9.

NOTE: Treestand should ALWAYS be fully assembled

on the ground prior to mounting it in the tree.

16. For Model RE652, attach the ladder curtain now. The side

of the curtain with numerous Velcro loops is the top side

of the curtain. Attach the top side of the curtain to the

shooting rail by wrapping all Velcro attachment points

around the tubing and securing together. The curtain

should be positioned with the zippered door on the front/

center of your ladder for entry and exit purposes. Once

the top of the curtain is secured properly, pull the bottom

edges of the curtain down around the foot platform. The

sewn-in elastic bungee will securely grab the lower corners

of your platform.