Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

Operator's Manual

ROGUE XL Hang-On Stand

lever-action hang-ons

All assembly must be done in this order at ground level

before use.

Do not remove labels/warnings from product, they are

there for your safety.

Recommended for adult use only.

ASSEMBLY INSTRUCTIONS

FIGURE 1

FIGURE 2

NOTE: When selecting a tree to install the treestand in, never use

a treestand on a dead, leaning, diseased or loose barked tree, or

a utility pole. Always avoid electrical power lines.

1. Attach the Teartu seat assembly (1) onto the seat post (2) using

two 5/16-18 X 2-3/4 IN bolts (7), eight yellow plastic washers (9)

and two 5/16-18 locknuts (13). SEE FIGURE 1.

NOTE: You must now tighten all nut and bolt assemblies. Be sure

not to over-tighten or crush tubing when tightening!

NOTE: Using powder graphite lubricant (not included) during

assembly of moving parts will help eliminate noise during use!

2. Bolt the end of both cables (4) onto the platform (3) using the

two 5/16-18 X 1-1/2 IN bolts (12), 5/16 IN washers (14) and

locknuts (13). SEE FIGURE 2.