Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
9
Operator's Manual
LITE FOOT ALUMINUM Hang-On Stand
FIGURE 11
!
FIGURE 9
!
warning tag
oat buckle
sewn loop
FIGURE 10
!
sewn loop
roller bar
end tail
of strap
smooth side
TREE ATTACHMENT INSTRUCTIONS
1. At desired height, attach by following instructions - a,b,c,d,e,f.
NOTE: Stand should be attached to tree with platform folded in
an upright position!
a. Lengthen strap by pulling oat buckle away from strap - this will
allow strap to slide around oat buckle roller bar.
b. With the sewn loop of the long side strap attached correctly, take
sewn loop on oat buckle end and wrap around tree. Be sure the strap
is even and at the same level all the way around the tree. Also, be
sure there are no twists in the strap. Connect sewn loop to opposite
side of stand by correctly looping over opposite oval mount. Be
absolutely sure both sewn loops are securely attached and can not
come o. SEE CRITICAL STRAP ATTACHMENT INSTRUCTIONS.
c. Pull on excess end of strap rmly - snugging up stand to tree.
SEE FIGURE 6.
NOTE: Platform must be folded up while doing this.
d. While platform is still folded up, push treestand in a downward
direction to further tighten strap. SEE FIGURE 7.
e. Once securely attached, pivot the platform down. This lever-action
will snug stand up tight to tree to prevent any shifting. Redo as
necessary to accomplish a snug stand-to-tree t. All four contact
bars must be touching tree! SEE FIGURE 8.
f. The tension on strap will not allow any slippage due to roller bar
tension of buckle. Proper installation should be checked prior to
stepping onto platform to ensure safety.
2. Before stepping down onto center of stand platform, be sure it is secured
properly and is tight against tree with all four contact bars touching tree!
3. Carefully step onto stand platform to be sure you have a solid feel
against tree and platform is level. Seat folds down for sitting and tips
back for standing.
4. To remove stand, fold platform back up and pull on buckle hand
strap to release tension on roller bar.
THREADING THE FLOAT BUCKLE
Always check the condition of your Big Foot strap before use. If strap
becomes twisted or if you need to replace a worn or damaged strap,
make sure to follow these instruction to ensure proper assembly.
1. Hold oat buckle so warning tag faces upward. SEE FIGURE 9.
2. Feed end tail of strap up through the bottom of the oat buckle on
the sewn loop side of the roller bar. SEE FIGURE 10.
NOTE: Smooth side of end tail must face sewn loop.
3. Feed end tail over roller bar and down through oat buckle.
SEE FIGURE 11.
4. Pull end tail away from oat buckle. SEE FIGURE 11.
FIGURE 6
FIGURE 8
excess end
of strap
platform
seat
oat buckle
oat buckle
WARNING
Platform must be folded up to remove stand! This allows
slack in strap for removal.
FIGURE 7