Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

Operator's Manual

LITE FOOT ALUMINUM Hang-On Stand

All assembly must be done in this order at ground

level before use.

Do not remove labels/warnings from product, they are

there for your safety.

Recommended for adult use only.

1. Bolt the metal seat frame (2) onto the seat posts (4) using two

5/16-18 x 2-1/2 IN bolts (11), 5/16-18 locknuts (14) and eight

nylon washers (17). SEE FIGURE 1.

NOTE: DO NOT tighten all nut & bolt assemblies completely!

2. Attach removable seat pad (5) to metal seat frame (2) by

sliding seat frame into pocket. Wrap the seat's hook and

loop attachment straps or buckle straps around seat frame

and secure together. Snap the side release buckle together

for buckle style seats. Pull straps tight so seat is not loose.

3. Attach cables (3) onto platform (1) using two 1/4-20 x 1 IN

bolts (9), 1/4-20 locknuts (13) and 1/4-20 steel washers (15).

SEE FIGURE 2.

NOTE: You must now tighten all nut & bolt assemblies. Be

sure not to over tighten or crush tubing when tightening!

NOTE: Using powder graphite lubricant during assembly

of moving parts will help eliminate noise during use!

ASSEMBLY INSTRUCTIONS

FIGURE 1

FIGURE 2