Installation Instructions

Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-56

Operator's Manual

Hang-On Stands

ASSEMBLY INSTRUCTIONS

RE554, RE555



IMPORTANT ASSEMBLY TIP: Do not tighten any nut and bolt combi-

nations completely until all parts are assembled together! Finger

tighten plus one turn of a wrench only! This will temporarily hold the

lock nut on the bolt while helping alignment of all parts! After all parts

are assembled together, all nut & bolt combinations must be com-

pletely tightened.

1. Bolt the metal seat frame (C30) onto the seat post using the (2) provided

1/4-20 x 2-1/4" bolts, locknuts and (6) nylon washers. SEE FIGURE 1.

DO NOT tighten all nut & bolt assemblies completely!

2. Attach removable seat cushion to metal seat frame by sliding seat

frame into pocket. Wrap the Velcro seat straps or buckle straps

around seat frame and secure together. Snap the side release buckle

together for buckle style seats. Pull straps tight so seat is not loose.

3. Bolt cables onto platform using the (2) provided 5/16 x 1-1/2" bolts and

locknuts. SEE FIGURE 2. You must now tighten all nut & bolt

assemblies. Be sure not to over tighten or crush tubing when

tightening!

NOTE: Using powder graphite lubricant during assembly of moving

parts will help eliminate noise during use!

platform cable

5/16-18 x 1-1/2" bolt

locknut

FIGURE 2

seat post

1/4-20 x 2-1/4"

bolt

nylon washer

locknut

FIGURE 1

nylon washer

seat frame

RE554 / RE555