Installation Guide

STEP 9

1. Attach 1 drawer side panel (11) to drawer back board (10) by inserting 2 screws (F) through holes on

drawer side panel (11) then tighten to drawer back board (10).

2. Repeat above step to assemble another drawer side panel (11) to drawer back board (10).

3. Slide drawer bottom board (12) into grooves on both drawer side panels (11).

4. Attach drawer front board (13) to drawer side panels (11) and drawer bottom board (12) by inserting

drawer bottom board (12) into groove on drawer front board (13), then inserting 4 screws (F) through

holes on drawer side panels (11) and tighten to drawer front board (13).

5. Slide drawer into pre-assembled drawer holders.

6. Insert 2 drawer plastic stoppers (H) to prevent drawer from pulling out.

STEP 10

1. Attach magnet plate (L) to door (9) by inserting 2 wood screws (D) through holes on magnet plate (L)

then tighten to door (9).

2. Attach 2 metal hinges (I) to door (9) by inserting 4 wood screws (D) through holes on metal hinges (I)

then tighten to door (9).

3. Attach knob (J) to door (9) by inserting 1 machine screw (K) through hole on door (9) then tighten to

knob (J).

4. Attach metal hinges (I) to lower right side panel (3) by inserting 4 wood screws (D) through holes on

metal hinges (I) then tighten to lower right side panel (3).

5. Insert 4 plastic holders (O) into holes on lower left side panel (2) and lower right side panel (3). All 4

plastic holders (O) should be at the same height.

6. Place shelf (6) onto plastic holders (O).