Instructions / Assembly

STEP 7

1. Screw in 2pc cam bolt (B) into the pre-threaded holes on the middle connection board (8).

2. Insert 8pc wooden dowels (A) into the holes on the lower left side panel (18), lower right side panel (17) and

lower section top cross bars (15).

3. Turn over board(8) over and attach to pre-assembled lower left side panel (18), lower right side panel (17) and

lower section top cross bars (15) by insert the wood dowel (A) into the dowel holes and insert the cam bolt

(B) into the cam lock holes on the lower left side panel (18), lower right side panel (17) and lower section top

cross bars (15).

4. Insert 2pc cam locks (C) into the cam lock holes on the lower left side panel (18) and lower right side panel

(17), then rotate clockwise to secure the cam bolt (B) in place by using a Philip Screwdriver.

5. Screw 4pc wooden screws (O) through the holes on the lower left side panel (18) and lower right side panel

(17) and tighten to rear lower cross bar (16).