Installation Guide

STEP 5
1. Attach magnet (H) to bottom of top board (7) by inserting 2 screws through holes on
magnet (H), then tighten to top board (7).
2. Insert 2 screws (Q) through sliding bracket (P) into holes on top board (7)
3. Screw 4 cam bolts (B) into cam bolt holes on top board (7).
4. Attach top board (7) to upper left side panel (4) and upper right side panel (3) by inserting
cam bolts (B) into cam lock holes on upper left side panel (4) and upper right side panel (3).
5. Insert 4 cam locks (C) into cam lock holes on upper left side panel (4) and upper right side
panel (3), then rotate clockwise to secure cam bolts in place.
STEP 6
1. Screw 4 cam bolts (B) into cam bolt holes on lower left side panel (17) and lower right side
panel (18).
2. Attach 2 lower section top cross bars (15) to lower left side panel (17) by inserting cam
bolts (B) into cam lock holes.
3. Insert 2 cam locks (C) into cam lock holes on lower section top cross bars (15), then rotate
clockwise to secure cam bolts (B) in place.
4. Attach rear lower cross bar (16) to lower left side panel (17) by inserting dowels into holes
on lower left side panel (17).
5. Attach lower right side panel (18) to lower section top cross bars (15) and lower cross bar
(16) by inserting cam bolts (B) into cam lock holes on lower section top cross bars (15) and
inserting dowels into dowel holes on lower section top cross bar (15) and lower right side
panel (18).
6. Insert 2 cam locks (B) into cam lock holes on lower section top cross bars (15), then rotate
clockwise to secure cam bolts (B) in place.