Installation Guide

- 7 -

STEP 6

1. Press 14 plastic caps (E) into the wood screw holes on the 2 upper side frames (2) and 2 lower

side frames (5).

2. If added pressure is needed to keep the plastic cap in place – cover the cap with a piece of paper

and tap lightly with a hammer to secure the cap.

STEP 7

1. Drill 2 holes on the wall by using the template drawing(included) w/hole positions as a guideline.

2. Insert 2 plastic anchors (C) into the 2 holes on the wall.

3. Insert 2 wood screws (D) through the holes on the rear top board cross bar (6), then tighten to (C)

with a Philips screwdriver.