Instructions / Assembly

TF2246501-RG-00 ENG Page 12 of 16 20160608-Ver.1

3. Insert the burner through the

bottom of the stand (3), in between

wind shield (F) (side with rectangle

lip) and burner support bar (G).

4. Unscrew the pre-assembled nut from the threaded

pin of the burner (5). Align timer control box (6) to the

timer box support bar (4) and fix it with 2 pieces

M6x12 screws by going through the support bar (4)

and then to the time box (6). Then align burner (5)

base to burner support bar (G). Align holes on heat

shield (11) with threaded pin and alignment pin of the

burner (5) through hole in burner support bar (G),

then through small hole of heat shield (11). The

alignment pin on bottom of burner (5) must be

inserted through the large hole of the heat shield (11),

Tighten hex nut onto bolt of the burner (5). Finally, fix

the support bar (4) to legs of stand with 2 pieces

M6x12 screw by going through the holes on legs and

then through the holes of support bar (4). Tighten the

screws with 2 pieces M6 nuts.

5. Align the tip guard support (2)

with 4

and 5

holes to stand and

tighten with bolt and nut.

Tighten align the tip guard (1) to the

hole of support (2) and tighten it

with crosshead bolt and nut.