30 QT. Aluminum Turkey Fryer Set Model # TF2089904-RG-00 Assembly, Use and Care Manual For Outdoor Use Only Tools required: Phillips screwdriver / Adjustable wrench This instruction manual contains important information necessary for the proper assembly and safe use of the appliance. Read and follow all warnings and instructions before assembling and using the appliance. Follow all warnings and instructions when using the appliance. Keep this manual for future reference.
DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call your fire department. Failure to follow these instructions could result in fire or explosion which could cause property damage, personal injury or death. DANGER 1. Never operate this appliance unattended. 2. Never operate this appliance within 10 ft. (3.0 m) of any structure, combustible material or other gas cylinder. 3.
CAUTION CAUTION: Indicates a potentially hazardous situation or unsafe practice which, if not avoided, may result in minor or moderate injury. WARNING 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Never leave the appliance unattended. Keep children and pets away from the appliance at all times. The use of alcohol, prescription or non-prescription drugs may impair the consumer’s ability to properly assemble or safely operate the appliance.
WARNING Installation Safety Precautions. Use appliance only with LP (propane) gas and the regulator / valve assembly supplied. Installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58; or Natural Gas and Propane Installation Code, CSA B1 49.1.
WARNING Never use a cooking vessel larger than 30 qts., diameter greater than 11-3/4 inches and taller than 15-1/2 inches. Never fill pot above upper fill line. Oil can splatter causing staining or discoloration to ground surface. Never place empty cooking vessel on the appliance while in operation. Use caution when placing anything in the cooking vessel while the appliance is in operation. Never move the appliance when in use. Allow the cooking vessel to cool before moving or storing.
LP Tank Removal, Transport and Storage Turn OFF all control knobs and LP tank valve. Turn coupling nut counterclockwise by hand only – do not use tools to disconnect. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane.
Always keep new and exchanged LP tanks in upright position during use, transit or storage. Leak test new and exchanged LP tanks BEFORE connecting to appliance. LP Tank Leak Test For your safety Leak test must be repeated each time LP tank is exchanged or refilled. Do not smoke during leak test. Do not use an open flame to check for gas leaks. Appliance must be leak checked outdoors in well-ventilated area, away from open flames or sparks.
Disconnecting Regulator to the LP Tank 1. Turn control knob of regulator to the OFF position. 2. Turn LP tank OFF by turning hand wheel clockwise to a full stop. 3. Turn the coupling nut counterclockwise to loosen the connector. Loose by hand only – do not use tools. 4. When disconnected, the regulator should be hung on the hook attached to the appliance. WARNING Do not insert any tool or foreign object into the valve outlet or safety relief valve. You may damage the valve and cause a leak.
Lighting Instructions Note: Do Not lean over LP cooker while lighting. Step Procedure Illustration 1. Read all instructions before lighting. 2. Turn regulator control valve to OFF position. 3. Fully turn timer control knob clockwise. 4. Fully open LP tank valve. 5. Light match and place it over burner. Tip: Wooden kitchen match works best. PRESS and continually HOLD down push button of safety valve while slowly turning ON the regulator control valve.
CAUTION If burner does not light OR if burner flame is accidentally extinguished, turn knob to OFF, wait 5 minutes, try again. If the burner does not ignite with valve open OR if burner flame is accidentally extinguished after lighting, gas will continue to flow out of the burner and could accidentally ignite with risk of injury. Burner Flame Check Light burner, rotate knob from HIGH to LOW. You should see a smaller flame in LOW position than seen on HIGH. Always check flame prior to each use.
Steps for Cleaning the Burner: 1. Remove orifice / hose from the burner. 2. Look inside the burner tube for nests, webs, or mud. 3. 4. 5. To remove the above obstructions, use an accessory flexible venture brush or bend a small hook on one end of a long flexible wire such as the one in small picture. Inspect and clean the burner if needed. Reattach orifice / hose to burner.
Suggested Cleaning Materials: Mild dish washing liquid detergent Wire brush Nylon cleaning pad Hot water Paper clip Soft brass bristled brush Component Cleaning: Burner: Wire brush loose corrosion from burner exterior. Clean clogged gas port holes with an opened paper clip. Replace corroded or damaged burners that would emit excess gas. Cooking surfaces, pots and pans: Clean the cooking surface with soapy water and a nylon cleaning pad.
Product Diagram 11A TF2089904-RG-00 English Page 13 of 23 20170516 V.
Component List 1. Welded Stand 2. Leg 3. Stand Ring 1pc 3pcs 5. Small T-Support 6. Adjustable Pot Tip Leg (With Support Bar For Timer) Guard 1pc 7. Heat Shield 2pcs 8. Auto-Shut Off Valve, Timer Control Box, Gas Hose & Regulator Assembly 1pc 9. Burner 4. Small T-Support Leg 2pcs 10. 30QT Turkey 1pc 1pc 11. Pot Lid 12. Turkey Stand Fryer 11A. Lid Handle 1pc 13. Turkey Hook 14. Regulator Hook 1pc TF2089904-RG-00 English 1pc 1pc 1pc 15. Thermometer 1pc Page 14 of 23 1pc 20170516 V.
Hardware List Part Description A Bolt M6 x 12 18 B Nut M6 16 C Bolt M6 x 10 (Silver) 2 D Nut M6 (Silver) 2 Diagram Assembly Instructions: 1. Attach Burner (9) to Automatic Shut Off Valve in the Timer Control Box (8) by turning the burner clockwise. Do not fully tighten burner to the valve, tighten until 3 threads remain visible on the valve. Attach thermocouple to thermocouple bracket which has been fixed to the burner. Three Visible Threads Qty.
3. Assemble the Leg (2) to Welded Stand (1) by using 6pcs Bolt M6 x 12 (A) and 6pcs Nut M6 (B). A B 2 1 2 4. Assemble the Leg (2) to Stand Ring (3) by using 3pcs 4 3 Bolt M6 x 12 (A) and 3pcs Nut M6 (B). Install the Small T-Support Leg (4) and (5) onto the Stand Ring (3) with 3pcs Bolt M6 x 12 (A) and 3pcs Nut M6 (B). 3 B A 2 5 5. Unscrew the pre-assembled nut from the threaded pin of the Burner (9).
7. Mount the Adjustable Pot Tip Guard (6) on to Welded Stand (1) by 2pcs Bolt M6 x 12 (A) and 2pcs Nut M6 (B). 6 1 B A 8. Thread Regulator Hook (14) through hole on side of regulator. 14 9. When transporting or storing LP cooker without tank attached, hook regulator onto burner or cooker stand to prevent damage to regulator. 11A 10. Attach the Lid Handle (11A) to the Lid (11) by using 2pcs Bolt M6 x 10 (C) and Nut M6 (D).
The following safety measures are recommended when using your turkey fryer set. LOCATION MATTERS Select a safe place to fry your turkey. It should be in an open area, outside, and on a cement or brick surface. Place the liquid propane gas tank and fryer so that any wind blows the heat of the fryer away from the gas tank. Never use your fryer in an enclosed area, near a wall or on a wooden deck. Keep a minimum clearance of 10 feet from the sides, front and back of the fryer to any construction.
FRY WITH CARE Check your hose at both ends for proper connection. Also, place the LP tank and hose so that they are not located directly next to the fryer (see photo). Center the pot over the burner on the cooker. Fill the pot to the mark with peanut oil. Do not place an empty cooking vessel on the appliance while in operation. Placing an empty cooking vessel on the appliance while in operation will result in melting the cooking vessel.
DANGER Do not fill past the maximum fill line marked on the Pot. An oil overflow may occur resulting in a fire which could cause property damage, personal injury or death. Follow directions above to prevent this. Do not place an empty cooking vessel on the appliance while in operation. Placing an empty cooking vessel on the appliance while in operation will result in melting the cooking vessel. Use caution when placing anything in cooking vessel while the appliance is in operation.
Trouble Shooting PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION The burner does not light up. The connection between the regulator Check and make sure the regulator coupling nut is and LP Tank are not in good condition. tightened to the LP tank valve. The LP tank valve and regulator The regulator control valve and LP tank valve is control valve do no open. open during normal operation.
LIMITED WARRANTY 1. Manufacturer warrants this Product to be free from defects in workmanship and materials for a period of Ninety (90) days from the date of purchase, PROVIDED claims are submitted, in writing, with proof of purchase. 2.
TF2089904-RG-00 English Page 23 of 23 20170516 V.