User's Manual

Wireless Array
164 Configuring the Wireless Array
to your deployment, select it and click Apply. For example, the High-
Density option uses best practices to configure the Array for high density
settings such as lecture halls, convention centers, stadiums, etc.
8. IAP Settings:
Figure 96. LEDs are Switched On
Enable/Configure All IAPs: Click on the Execute button to enable and
auto configure all IAPs (a message displays the countdown time — in
seconds — to complete the auto-configuration task). When an IAP is
enabled, its LED is switched on.
9. Click Save changes to flash at the upper right to make your changes
permanent, i.e., these settings will still be in effect after a reboot.
LED on