User's Manual

Wireless Array
Configuring the Wireless Array 279
IAP Settings
This window allows you to enable/disable IAPs, define the wireless mode for
each IAP, specify the channel to be used and the cell size for each IAP, lock the
channel selection, establish transmit/receive parameters, select antennas, and
reset channels. Buttons at the bottom of the list allow you to Reset Channels,
Enable All IAPs, or Disable All IAPs. When finished, click Save changes to flash
if you wish to make your changes permanent.
Figure 149. IAP Settings
You may also access this window by clicking on the Array image at the lower left
of the WMI window — click the orange Xirrus logo in the center of the Array. See
“User Interface” on page 84.
Procedure for Auto Configuring IAPs
You can auto-configure channel and cell size of radios by clicking on the Auto
Configure buttons on the relevant WMI page (auto configuration only applies to
enabled radios):
 For all radios, go to “Advanced RF Settings” on page 320.
 For all 802.11a settings, go to “Global Settings .11an” on page 298.
 For all 802.11bg settings, go to “Global Settings .11bgn” on page 303.
 For all 802.11n settings, go to “Global Settings .11n” on page 309.