User's Manual

Wireless Array
Configuring the Wireless Array 363
Cluster Operation
This window puts WMI into Cluster Mode. In this mode, all configuration
operations that you execute in WMI or CLI are performed on the members of the
cluster. They are not performed on the Array where you are running WMI, unless
it is a member of the cluster.
You must use the Save changes to flash button at the top of configuration
windows to permanently save your changes in Cluster Mode, just as you would
in normal operation. When you are done configuring Arrays in the cluster, return
to this window and click the Exit button to leave Cluster Mode.
Figure 175. Cluster Mode Operation
Procedure for Operating in Cluster Mode
1. Operate: Click the Operate button to the right of the desired cluster. A
message informs you that you are operating in cluster mode. Click OK.
The Operate button is replaced with an Exit button.
Figure 176. Cluster Mode Activation
2. Select a WMI window for settings that you wish to configure for the
cluster, and proceed to make the desired changes.

An XR-500 or XR-1000 Series Array cannot act as the Cluster controller. It
will operate correctly as a member of a cluster.