User's Manual

Wireless Array
346 Configuring the Wireless Array
and the maximum number of IAPs in the link. Then you will select the IAPs to be
used in the link. When the client link is created, each member IAP will associate to
an IAP on the host Array.
You may wish to consider configuring the WDS link IAPs so that only the WDS
link SSIDs are active on them. See “Active IAPs” on page 266.
Figure 166. Configuring a WDS Link

Once an IAP has been selected to act as a WDS client link, you will not be
allowed to use auto-configured cell sizing on that IAP (since the cell must
extend all the way to the other Array).

When configuring WDS, if you use WPA-PSK (Pre-Shared Key) as a
security mechanism, ensure that EAP is disabled. Communication between
two Arrays in WDS mode will not succeed if the client Array has both PSK
and EAP enabled on the SSID used by WDS. See SSID Management.

TKIP encryption does not support high throughput rates, per IEEE 802.11n.
TKIP should never be used for WDS links on XR Arrays.

WDS is available on all Xirrus Arrays, including XR-500 and XR-1000
Series Arrays with two radios (WDS will operate on either of the radios).
a2(52)
a3(149)
a4(40)
a10(52)
a9(149)
a8(40)
CLIENT
HOST
Wired LAN
Client
Link