User Manual
Table Of Contents
- 1) You Need the Following Items
- 2) Choose a Suitable Location
- 3) Prepare the Mounting Location
- 4) Attach the Mounting Plate to the Access Point
- 5) Mount the Access Point on a Pole or Wall
- 6) Ground to Earth Ground
- 7) Install an Antenna
- 8) Prepare the Ethernet Cable with the Waterproof Shell
- 9) Connect the Cables
- 10) Log In to the Access Point
- 11) Configure the Access Point
- 12) Secure Low Level Access to the Access Point
- Drawings
- Customer Support
- Notices, Warnings, & Compliance Statements
- 未命名
XR520H Quick Installation Guide
Use the following steps to replace the default XBL username and password. These steps use CLI
commands.
1. To access CLI via the WMI, click CLI under the Tools section on the left.
2. If Xircon access at the XBL level is to be allowed, use the following three commands to change
the XBL username and password from the default values of admin/admin. In the example
below, replace newusername and newpassword with your desired entries. Note that these
entries are case-sensitive.
Array42#(config)#boot-env
Array42#(config-boot)#set username newusername
Array42#(config-boot)#set password newpassword
Array42#(config-boot)#save
Saving boot environment .... OK
Array42(config-boot)# exit
3. It is possible to change Xircon access permission to allow Xircon to access the Access Point at
the CLI level only, or at the XBL level only. See the Xircon User Guide for details.
Drawings
XR520H Dimensions
- 11 -