User Manual
Table Of Contents
- 1) You Need the Following Items
- 2) Choose a Suitable Location
- 3) Prepare the Mounting Location
- 4) Attach the Mounting Plate to the Access Point
- 5) Mount the Access Point on a Pole or Wall
- 6) Ground to Earth Ground
- 7) Install an Antenna
- 8) Prepare the Ethernet Cable with the Waterproof Shell
- 9) Connect the Cables
- 10) Log In to the Access Point
- 11) Configure the Access Point
- 12) Secure Low Level Access to the Access Point
- Drawings
- Customer Support
- Notices, Warnings, & Compliance Statements
- 未命名
XR520H Quick Installation Guide
10) Log In to the Access Point
NOTE: If you are a Xirrus Cloud customer, your Access Points are completely managed by
XMS Cloud, and you may skip all of the remaining steps (10, 11 and 12). In fact, you will
not be able to access CLI or the Web Management Interface under normal operating
circumstances.
Xirrus Cloud customers should wait five minutes, then log on to XMS Cloud to
view/manage this Access Point. In the event that your connection to the Cloud has been
interrupted for an extended period of time, you may contact Xirrus technical support for
help with local access to the Access Point.
Establish a network connection to the Access Point using a web browser. If you are using
DHCP and DNS, enter the Access Point's default host name in the URL field. The default
host name is its serial number (for example, XR0823090CACD).
If you are not using DNS and DHCP, enter the IP address in the URL field. Be aware of the
following:
− By default, the Access Point tries to obtain an IP address via DHCP. If it cannot do so,
the factory default is a static IP address of 10.0.2.1 with a mask of 255.255.255.0 on its
Gigabit POE port.
Take care to ensure that your network is not using the 10.0.2.1 IP address prior to
connecting the Access Point to the network.
− To connect to the Access Point in this case, you must set your computer to be in the same
subnet as the Access Point: set your IP address to be in the 10.0.2.xx subnet, and set its
subnet mask to 255.255.255.0. If this subnet is already in use on your network, you may
connect your computer directly to the Access Point by connecting the computer to the
power injector’s IN port temporarily (this port may be called the SWITCH port or the
DATA port on your injector).
− If the assigned IP address is unknown, you may use the Xirrus Xircon utility to
communicate with any XR520H on the local network. Note that the XR520H does not
have a console port, so Xircon has been specifically designed to substitute for the use of
a console port. See “Secure Low Level Access to the Access Point” in Step 12 for more
information about Xircon.
If your browser reports a Security exception, accept it and continue on to the Access Point’s
Web Management Interface (WMI).
At the login prompt, enter the default user name / password (the default is admin for both).
You are now logged in to the Wireless Access Point.
- 8 -