User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- Introduction
- Installing the Wireless Array
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Installing Your Wireless Array
- Powering Up the Wireless Array
- Establishing Communication with the Array
- Entering the License
- Performing the Express Setup Procedure
- The Web Management Interface
- Viewing Status on the Wireless Array
- Configuring the Wireless Array
- Express Setup
- Network
- Services
- VLANs
- Tunnels
- Security
- SSIDs
- Groups
- IAPs
- WDS
- Filters
- Clusters
- Using Tools on the Wireless Array
Wireless Array
66 Installing the Wireless Array
Establishing Communication with the Array
The Array may be configured through the Command Line Interface (CLI) using
SSH, or on a browser via the graphical Web Management Interface (WMI). You
may use the CLI via the serial management port (console—on all Arrays except
the XR500 and XR-1000 Series), the Fast Ethernet port, or any of the Gigabit
Ethernet ports. You can use the WMI via any of the Array’s Ethernet ports.
Figure 31. Network Interface Ports—XR-1000 Series
Figure 32. Network Interface Ports—XR-2000 Series
Figure 33. Network Interface Ports—XR-4000 Series
Gigabit POE (gig1)
Serial (Console)
Gigabit POE (gig1)
Serial (Console)
Gigabit POE (gig1)
Gigabit 2 (gig2)